Page 2 of 2

Re: SCALEXTRIC | Big issue with C8295 Elevated Cross Over

Posted: Wed 5. Feb 2020, 13:23
by david oxford
Thanks, Jan :)

Re: SCALEXTRIC | Big issue with C8295 Elevated Cross Over

Posted: Wed 5. Feb 2020, 20:52
by Local Hero
Great news Jan,
Thank you very much

Re: SCALEXTRIC | Big issue with C8295 Elevated Cross Over

Posted: Sat 15. Feb 2020, 20:09
by david oxford
And proof that it's good in the now-available 6.2.5:
Screenshot 2020-02-15 at 20.04.51.jpg
Screenshot 2020-02-15 at 20.04.51.jpg (49.68 KiB) Viewed 953 times

Re: SCALEXTRIC | Big issue with C8295 Elevated Cross Over

Posted: Sun 16. Feb 2020, 20:03
by Local Hero
Oh!!! this is a wonderfull new.

Re: SCALEXTRIC | Big issue with C8295 Elevated Cross Over

Posted: Sun 16. Feb 2020, 23:13
by david oxford
With R3 curves, the equivalent pattern is:
Screenshot 2020-02-16 at 23.11.11.png
Screenshot 2020-02-16 at 23.11.11.png (74.36 KiB) Viewed 942 times
Personally, I prefer "transition curves", where you lead in gently and get tighter, before leading out gently again. (e.g. R3 then R2 then back to R3). I still need to work out the pattern for that though!

Re: SCALEXTRIC | Big issue with C8295 Elevated Cross Over

Posted: Mon 17. Feb 2020, 20:37
by Local Hero
David,
I have found another isuue but I don't have permission to publish a new issue.
I have tried but I can't.

I have tried to design the attached Scalextric Set with RailModeller Express but there are a gap and I can't close the Set.

Re: SCALEXTRIC | Big issue with C8295 Elevated Cross Over

Posted: Thu 20. Feb 2020, 22:51
by david oxford
Are you sure it's RailModeller that is wrong, though?

You have one diagonal half-straight, which is hard to balance out exactly. Also, a gap that small is usually closeable in practice due to the track's flexibility.

Re: SCALEXTRIC | Big issue with C8295 Elevated Cross Over

Posted: Fri 21. Feb 2020, 09:04
by Local Hero
Hi David,
I am not sure who is wrong.

You are wright about closing the gap.

NOTE 1:I took that Set from:
https://www.slotcar-union.com/es/fun-tr ... 4-set.html

NOTE 2:
I don't know what is a diagonal half-straight.

Thank you for your help

Re: SCALEXTRIC | Big issue with C8295 Elevated Cross Over

Posted: Mon 24. Feb 2020, 11:08
by david oxford
This is a half-straight (C8207) and is on a diagonal. It's hard to make things match up exactly when you have an odd number of diagonal pieces, in general.
diagonal-half-straight.png
diagonal-half-straight.png (24.78 KiB) Viewed 887 times
My conclusion is that the RailModeller version of this is probably right.